How to order your pontoon boat Bow Mate.

There are numerous pontoon boat manufacturers, makes and models. 

Additionally, if you are not aware, there are no 2 pontoon boats that measure identically. 

In order to ensure we are providing you with the correct Bow Mate, we need to double check a few things and we list the process below. 

Please be patient, the end result far outweighs the first few steps. 

Print the dimensions spec drawing shown here to measure the critical pontoon boat mounting areas. This just confirms the assembly we will prepare and send to you. If there are concerns then please email info@thebowmate.com or call 317 441 1817. 

When dimensions are complete, email to info@TheBowMate.com

This section will be completed directly

• Remove Hinge Pins from THE BOW MATE.
• Using 2 adults (1 at each end) lift THE BOW MATE safely into position.
• Align One Side ONLY with Pontoon Boat Eyelet, Install and secure Hinge Pin.
• Align opposite side with Pontoon Boat Eyelet. Install and secure Hinge Pin.
• IF boat is IN the water, Raise and Lower THE BOW MATE to become familiar with the full range of motion, and practice securing to Forward top door frame area.
• IF boat is ON it’s trailer, you will NOT be able to Raise and Lower THE BOW MATE.
• Install and Uninstall THE BOW MATE repeatedly to safely understand the complete process.

• Position 2 adults at ONE end of THE BOW MATE.
• lightly lift that ONE end and remove Hinge Pin from THE BOW MATE. 
• ONE adult now supports the removed side of THE BOW MATE.
• Lightly lift the opposite side of THE BOW MATE and remove the Hinge Pin.
• Both adults carefully lift or lower and remove THE BOW MATE from its installed position. 
• Install and Un-install THE BOW MATE repeatedly to safely understand the complete process.

• THE BOW MATE is NOT intended for trailered use. 
• Do NOT float pontoon boat onto trailer with THE BOW MATE down.
• When in a DOWN or UP position, the corners of THE BOW MATE are in an extended and new location. Bumping into Docks, Marinas or other Boats can cause damage to THE BOW MATE and Docks, Marinas and other Boats.
• Install and Uninstall THE BOW MATE repeatedly to safely understand the complete process.
• NEVER use THE BOW MATE in a down position when pontoon boat is under power.
• Do NOT use THE BOW MATE as a jumping, diving or recreational platform. Injuries or death can occur.
• Do NOT tie off anchor to Eyelet or Cleat or THE BOW MATE Hinge Pins or damage to THE BOW MATE & your pontoon boat can occur.
• Maximum Load = 3 Adults or 450lbs / 205kg.